GeneSys Elektronik GmbH
In der Spöck 10
77656 Offenburg, Germany
+49 (0) 781 969279 0
Fax: +49 (0) 781 969279 11
ADMA option
Full-INS firmware license option
This unlocks the ADMANet data output and makes it possible to use further options such as Addon-DELTA or Addon-Filter.
Option RTK2: High-precision position measurement using correction data
The method is much more accurate than code-based location. The basic concept is to eliminate the various error sources of raw GNSS positioning by using a local base station whose exact position is known. For this purpose, correction data of a virtual base station of different correction data services can be requested, or a local base station with its own GNSS receiver is used.
Option Multi-GNSS: Use of multiple satellite systems such as GPS, GLONASS, Galileo, Beidou
By using these systems in addition to GPS the Receiver is able to track more Satellites which results in the following advantages: Reduced signal acquisition time. Improved position and timing accuracy. Reduction of problems caused by obstacles such as buildings and leaves Improved spatial distribution of visible satellites, resulting in improved position accuracy.
Option Dual-Ant: Two GNSS antennas option
The Dual-Ant option provides heading angle detection without initialization and control at very slow speeds. Among other things, this option is helpful when using robotic systems where a valid heading angle is needed right at the beginning. Note: Only available in combination with RTK2 activation and dual antenna capable GNSS receiver
Option Multi-CAN: Data output via several CAN channels simultaneously
Note: Separate CAN-2-5 cable is required Not available for ADMA-SPEED and ADMA-Slim
Option GNSS-Raw Data: Raw data output via Ethernet for post-processing
With the option you get access to the recorded GNSS raw data via the Ethernet interface and can significantly increase the GNSS accuracy in post-processing applications e.g. with our Post-Processing Software ADMA-PP.
Data logging is user-friendly with the free GeneSys Ethernet Logger software. The GNSS Raw Data option is available for all ADMA models Note: Separate WLAN router and Ethernet cable are required
Option DGNSS Correction Data: Correction data reception via Ethernet
The option provides the capability to receive DGNSS correction data forwarded from a second ADMA
via WiFi / Ethernet. This is the preferred option for multi-vehicle applications, e.g. LSS, ACC-, AEB- und FCW testing. This option is used in place of radio modems, increasing the availability of DGNSS correction data, especially on public roads.