ground-truth_rest

Option RTK2: High-precision position measurement using correction data

The method is much more accurate than code-based location. The basic concept is to eliminate the various error sources of raw GNSS positioning by using a local base station whose exact position is known. For this purpose, correction data of a virtual base station of different correction data services can be requested, or a local base station with its own GNSS receiver is used.

Option Multi-GNSS: Use of multiple satellite systems such as GPS, GLONASS, Galileo, Beidou

By using these systems in addition to GPS the Receiver is able to track more Satellites which results in the following advantages: Reduced signal acquisition time. Improved position and timing accuracy. Reduction of problems caused by obstacles such as buildings and leaves Improved spatial distribution of visible satellites, resulting in improved position accuracy.

Option Dual-Ant: Two GNSS antennas option

The Dual-Ant option provides heading angle detection without initialization and control at very slow speeds. Among other things, this option is helpful when using robotic systems where a valid heading angle is needed right at the beginning. Note: Only available in combination with RTK2 activation and dual antenna capable GNSS receiver

Post-Processing Software ADMA-PP

Much higher position accuracy in general and eliminates jumps in position during partial or total GNSS shading (e.g. on emergence from a tunnel) RTK correction data can be fed in without interruption Additional features: Moving Base Add-On / Delta multi Add-On Improved flexibility and accuracy by combining the forward / backward navigation solution Save time: Retroactively change the ADMA configuration and fewer initialization steps Track analysis, Road mapping, GIS data acquisition, Precise altitude profiling, Power train optimization, Consumption optimization, Verification of simulation models, Underground and tunnel survey

NTRIP-DGPS-Box 4

DGNSS Correction Data via GPRS from a GPS Base Station or RTK Network Provider User-friendly operating software for entering the GPRS network parameters GPRS mobile antenna with magnetic base for easy mounting on the vehicle roof Automatic dial-in and redial-in after connection failure

Mounting accessories

Seat rail adapter with ADMA mounting plate
Installation support for ADMA plus data acquisition systems with a quick-installation mounting pole or on-seat adapter
Mounting plate with quick-installation mounting pole
RT-Strut with ADMA mounting bracket

Option GNSS-Raw Data: Raw data output via Ethernet for post-processing

With the option you get access to the recorded GNSS raw data via the Ethernet interface and can significantly increase the GNSS accuracy in post-processing applications e.g. with our Post-Processing Software ADMA-PP. Data logging is user-friendly with the free GeneSys Ethernet Logger software. The GNSS Raw Data option is available for all ADMA models Note: Separate WLAN router and Ethernet cable are required

Option DGNSS Correction Data: Correction data reception via Ethernet

The option provides the capability to receive DGNSS correction data forwarded from a second ADMA via WiFi / Ethernet. This is the preferred option for multi-vehicle applications, e.g. LSS, ACC-, AEB- und FCW testing. This option is used in place of radio modems, increasing the availability of DGNSS correction data, especially on public roads.