Tobias Wagner

Applikationsingenieur | bei GeneSys seit 2014
linkedin
Technical Support CenterPosts by Tobias Wagner

Technical Paper – ADMA-PP Performance Indicators

In this test scenario, measurement data from an ADMA-G Pro+ with correction data was used as areference for a...

ADMA Export Restrictions

Due to the internally installed accelerometers, the inertial system ADMA is not covered by the German export list. Export...

GNSS Raw Data via Ethernet – Add-In

Introduction The GNSS raw data output via Ethernet is an additional functionality (Add-In) of the ADMA. GNSS raw data primarily...

Satel modem compatibility

3AS, Satelline Easy and 3ASd modems are compatible, 2 AS is not.

Relationship between Baud rate and Range of Satel Modems

Range Change It is possible to configure the following settings:1] Baud rate: 9600 bps | Channel spacing: 12.5 kHz2] Baud...

RSSI value of Satel UHF Modems

RSSI value The RSSI signal threshold defines the minimum power level (dBm) for receiving radio signals of the Satel UHF...

Satel LED Indicators

LEDINDICATIONOFF🔴🟠🟢RTSRTS-line status (D15 Pin 13)InactiveActive--CTSCTS-line status (D15 Pin 6)InactiveActive--TDTD-line status (D15 Pin 11)Radio modem is receiving data from the...

WiFi-Kit Technical Data

Ethernet ports1 x 10/100/1000 MbitWireless5 GHz | 2,4 GHzOutput power1300 mW max.Protocols802.11 ac | 802.11 b/g/nPoE inYesInput voltage10 –...

WiFi-Kit Configuration

If changes of the setting are required, the enclosed GeneSys software Network Device Configurator can be used. System Requirements The following...

WiFi-Kit LED Indicators

The LED indicates the strength of the Wireless signal and link activity of the Ethernet connection. LED 1️⃣ to 5️⃣Wireless...

Powering the WiFi-Kit

The device accepts powering from the Ethernet port passive Power over Ethernet (Passive PoE) 12-28V DC. The Package contains...

WiFi-Kit Mounting

There are two different mountings possible: Magnetic base mounting: on any flat metallic surfaces.Side window clamp mounting: if there is...