Tobias Wagner

Applikationsingenieur | bei GeneSys seit 2014
linkedin
Technical Support Center按职位 Tobias Wagner

Safety Notices

Please read all instructions before installing and powering the router. You should keep these instructions in a safe place...

NTRIP-DGPS-Box 4 Hardware

Front Panel Features SIM sockets: SIM 1 and SIM 2 are for use with the Subscriber Identification Module(s) SIMs. POWER LED:•...

NTRIP-DGPS-Box 4 Scope of Delivery

The NTRIP-DGPS-Box 4 is completely supplied including cable, antennas, software and manual.Other components are available; please contact us for...

NTRIP-DGPS-Box 4 Introduction

The NTRIP-DGPS-Box 4 includes a GPRS modem and a micor controller unit. The system establishes a connection to a...

ADMA ROS Driver

The ADMA ROS Driver provides a full ROS1 and ROS2 integration for the inertial navigation system ADMA. ROS is...

ADMA PP Batch Process

To integrate the ADMA-PP in a tool chain it can be called using Command Line Arguments (CLA).For this purpose,...

Measurement Requirements for ADMA PP

To increase the performance of post processing please note the following tips for data recording. Record the whole test drive....

ADMA PP Wizard

When you start up the ADMA-PP or create a new project, the configuration wizard will appear. These wizard guides...

ADMA PP Data output

ADMA-PP calculated output data is compatible with the ADMA online data. However, in ADMA-PP, the output data volumes are...

ADMA PP Data input

Required data packages In order to use ADMA-PP to calculate an offline navigation solution, the following sensor and GNSS data...

RINEX – ADMA Post Processing with offline correction data

ADMA PP can also be used to carry out DGNSS correction after the measurement event by using RINEX data...

ADMA PP Toolchain

The following image shows the ADMA PP toolchain including the data recording, the offline correction data, the offline ADMA...