Tobias Wagner, Autor bei GeneSys Elektronik GmbH

Standstill detection parameters

24. 2 月 2023

Automatic determination of the max rate threshold The threshold values for maximum rate at standstill can be determined automatically using...

Modify threshold for AutoInit and Heading Control

23. 2 月 2023

The AutoInit function of the ADMA is used to automatically set the ADMA inertial states after system start-up, including...

Compensating an ADMA misalignment

21. 2 月 2023

ADMA misalignment As described earlier, an exact alignment of the measurement axes with the vehicle's axes is rarely achieved. However,...

Compensating the installation position – Mounting Offsets

20. 2 月 2023

The ADMA, the GNSS antenna and external speed sensor can’t be mounted at the very same spot. The devices...

Compensate angle offsets with ADMA rotated in multiple axes

19. 2 月 2023

When the ADMA rotated orthogonally around multiple axes, please configure the offset angles according to the following table:

POI transformed ADMA data

18. 2 月 2023

In many cases it is necessary to output measurement data in a specific point of the car like the...

Relative Coordinate System

17. 2 月 2023

The ADMA can output position data referred to a relative coordinate system. This coordinate system can be defined by...

Dual Antenna configuration

17. 2 月 2023

Use Dual Antenna allows to configure the work mode of dual antenna systems. This option is only available at...

ADMA with DGNSS

15. 2 月 2023

This operating configuration constitutes the most advanced system stage providing the best possible performance. A determination of absolute positions...

External velocity

14. 2 月 2023

If the ADMA is supplied with an external velocity signal, the orientation angles for roll and pitch do not...

Steering and driving robot data output

13. 2 月 2023

Wiring ADMA and Steering / driving robot The following image shows the hardware setup for using an ADMA to control...

Modify thresholds for quality indication

12. 2 月 2023

After starting the measurement, the position-, tilt- and velocity-status is available after 120 sec. This status is based on...

Hi, I'm ADMI and I'm happy to help you!

I'm ADMI and will do my best to answer your technical questions accordingly.

Tobias Wagner