Tobias Wagner, Autor bei GeneSys Elektronik GmbH

NTRIP-DGNSS-Box 5 – Setup as ADMA Modem

3. 3 月 2023

When using the NTRP-DGNSS-Box 5 as correction data modem for the ADMA, the NTRIP Box Serial interface has to...

Single and Dual Antenna

3. 3 月 2023

All models of the ADMA family can be ordered as single or dual GNSS antenna version. Single GNSS antenna version For...

External velocity measuring system mounting

2. 3 月 2023

Usually, the external speed measuring system is attached to one side of the vehicle. For slalom tests involving a...

TCP/IP Settings for connecting to the ADMA Webinterface

28. 2 月 2023

The Webinterface is integrated in the ADMA. For access, the following settings of the network connection must be done: 1...

ADMA Webinterface

27. 2 月 2023

The ADMA provides options for certain user-specific and operational settings / configurations. On application of the supply voltage, the...

System and GNSS-Receiver information

26. 2 月 2023

To get system information open the menu SYSTEM. It delivers detailed information about the following system data: ADMA Information PropertyDescriptionAliasUserdefined name...

Functionality of the ADMA Standstill detection

25. 2 月 2023

The following describes standstill detection thresholds and their correct entry, which will increase the data integrity. Standstill allows a...

Standstill detection parameters

24. 2 月 2023

Automatic determination of the max rate threshold The threshold values for maximum rate at standstill can be determined automatically using...

Modify threshold for AutoInit and Heading Control

23. 2 月 2023

The AutoInit function of the ADMA is used to automatically set the ADMA inertial states after system start-up, including...

Compensating an ADMA misalignment

21. 2 月 2023

ADMA misalignment As described earlier, an exact alignment of the measurement axes with the vehicle's axes is rarely achieved. However,...

Compensating the installation position – Mounting Offsets

20. 2 月 2023

The ADMA, the GNSS antenna and external speed sensor can’t be mounted at the very same spot. The devices...

Compensate angle offsets with ADMA rotated in multiple axes

19. 2 月 2023

When the ADMA rotated orthogonally around multiple axes, please configure the offset angles according to the following table:

Hi, I'm ADMI and I'm happy to help you!

I'm ADMI and will do my best to answer your technical questions accordingly.

Tobias Wagner