How can I help you?
Account / Downloads
How can I help you?

Tobias Wagner

Applikationsingenieur | bei GeneSys seit 2014
linkedin
Technical Support Center按职位 Tobias Wagner

GNSS Receiver Update of the GPS Base

The presets mentioned below must be set for accessing the internal GNSS receiver via the service interface.• PC with...

Internal battery

The GNSS Base Station is delivered with an internal battery pack, which is capable of running up to 10...

Battery Replacement

At the following section you will find instructions on how to replace the internal batteries of the GNSS BASE...

GPS Base Technical Data

Storing To prevent battery damages please note the following steps before putting the GNSS Base Station in storage.• The internal...

IPS Introduction

This user manual serves as an aid in commissioning the IPS (Indoor Positioning System). The GeneSys IPS uses a network...

IPS Scope of delivery

DESCRIPTIONIPSIPS Rover🔵IPS Rover serial config cable 2 m (RLCAB151)🔵X IPS Beacons🔵X Beacon Power Cables 3 m (RLAB152)🔵X Tripods incl....

IPS Frontview and Interfaces

Connectors Beacons and Rovers got different interfaces. LED indicators Beacon LED COLORSTATUS DESCRIPTIONThe beacon is in bootloader mode.The beacon is connected via Bluetooth.The...

IPS Measurement Setup

Once the IPS is installed, the measurement setup has to be made for getting the first measurement data. Hardware Setup For...

IPS Hardware installation

Beacons The IPS needs at least 6 beacons in view of the rover at any time. The most simple installation...

IPS Technical Data

Overview Complete System (IPS + ADMA) Update rateUp to 1000 HzPosition accuracy0,02 m RMS 123Velocity accuracy0,09 km/h RMS 123Angle measurement accuracyUp...

Calibration – Whitepaper

High measurement quality and traceability according to ISO 17025 With calibration of the Inertial navigation Systems, GeneSys not only offers...

Technical Paper – ADMA-PP Performance Indicators

In this test scenario, measurement data from an ADMA-G Pro+ with correction data was used as areference for a...

GeneSys Elektronik GmbH
Maria-und-Georg-Dietrich-Str. 6
77652 Offenburg, Germany
+49 (0) 781 969279 0

Fax: +49 (0) 781 969279 11

Tech-News, Software- & Firmware-Updates sowie neue Features – direkt in dein Postfach.

Etwa 4× im Jahr. Kein Spam. Mehr Infos.

Copyright 2025 - GeneSys Elektronik GmbH